NordicTrack NTEL89010 user manual HOW to USE the Elliptical Crosstrainer, Incline Adjustment

Page 9

HOW TO USE THE ELLIPTICAL CROSSTRAINER

EXERCISING ON THE ELLIPTICAL CROSSTRAINER

To mount the elliptical crosstrainer, hold the handgrip pulse sensor and step onto the pedal that is in the lowest position. Next, step onto the other pedal. Push the pedals until they begin to move with a continuous motion. Note: The pedal disks can turn in either direction. It is recommended that you turn the pedal disks in the direction shown by the arrow below; however, to give variety to your exercise, you may turn the pedal disks in the opposite direction.

Handgrip

Pulse Sensor

Pedal

Pedal Disk

To dismount the elliptical crosstrainer, wait until the pedals come to a complete stop. The elliptical crosstrainer does not have a free wheel; the ped-

pedal. Slide the pedals forward or backward to the desired position, and then retighten the knobs. Make sure that both pedals are in the same position.

INCLINE ADJUSTMENT

As you exercise on the elliptical crosstrainer, you can vary the effect of the exercise by raising or lowering the incline frame. First, position the pedal arms side by side. Next, lift the incline frame slightly and pull the incline knob. Raise or lower the incline frame to the desired position and then release the incline knob.

Move the incline frame up or down slightly until the pin on the incline knob snaps into one of the holes in the incline bracket. Push the incline knob to make sure that the pin is fully inserted into the hole.

Incline

Knob

Incline

Frame

HOW TO USE THE UPPER BODY ARMS

als will continue to move until the flywheel stops. When the pedals are stationary, step off the highest pedal first. Then, step off the lowest pedal.

HOW TO ADJUST THE PEDALS

The upper body arms are designed to add upper-body exercise to your workouts. As you exercise, push

Upper Body Arms

The motion of the pedals is deter- mined by their position on the spring arms. Their are five dif- ferent pedal posi- tions. To adjust the pedals, first loosen the knob beneath each

Pedal

Knob

and pull the upper body arms in order to work your arms, back, and shoulders. To exercise only your lower body, hold the handgrip pulse sensor as you exercise.

Handgrip

Pulse

Sensor

9

Image 9
Contents QUESTIONS? Model No. NTEL89010 Serial NoCustomer HOT Line Table of Contents Important Precautions Front Before YOU BeginBack Right SideAssembly Welded Bolts Grease Post Pedal Tool Jack With the four screws. Make sure that no wires are pinched Installing the Receiver for the Optional Chest Pulse SensorIncline Adjustment HOW to USE the Elliptical CrosstrainerHOW to USE the Upper Body Arms HOW to Adjust the PedalsFeatures of the Console Console DiagramMake sure that the power supply is plugged HOW to USE the Manual ModeSelect the manual mode Training Zone bar-The TrainingPage Select one of the six smart programs HOW to USE a Smart ProgramStart the program Watch your progress with the two displaysSelect one of the heart rate programs HOW to USE a Heart Rate ProgramEnter your age Hold the handgrip pulse sensorAudio Adapter Cable Headphones HOW to Connect Your Home Stereo HOW to Connect Your Portable StereoHOW to Connect Your VCR HOW to Connect Your ComputerPressVCR. the play button on your CD player or Optional Chest Pulse Sensor HOW to USE Programs Directly from OUR WEB SiteHOW to Level the Elliptical Crosstrainer Maintenance and TroubleshootingExercise Intensity Conditioning GuidelinesWorkout Guidelines Exercise FrequencyQty Description Part LIST-Model No. NTEL89010NTEL89010ModelDRAWING-EXPLODEDNo Limited Warranty HOW to Order Replacement Parts