Assembly

Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two

included allen wrenches, assembly requires a phillips screwdriver			, an adjustable
wrench	, a rubber mallet	, and pliers	.

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 x 19mm	M8 Split	M10 Split	M8 Washer		M10 Washer	M10 Nylon
Screw (30)–2	Washer (58)–2	Washer (22)–8		(33)–2	(63)–2	Locknut (26)–4
M10 x 43mm Button Screw (65)–4		M10 x 56mm Button Screw (60)–4			M10 x 33mm Carriage Bolt (61)–2
1. Identify the Rear Stabilizer (59), which has Leveling				1		60
Feet (14) threaded into it. Attach the Rear Stabilizer to				1	60	60
Feet (14) threaded into it. Attach the Rear Stabilizer to
the Frame with the four M10 x 56mm Button Screws						22
the Frame with the four M10 x 56mm Button Screws						22
(60) and four M10 Split Washers (22).
						1
					22	59
					22
						14
2. Attach the Front Stabilizer (90) to the Frame (1) with				2		65
the four M10 x 43mm Button Screws (65) and four				2		65
the four M10 x 43mm Button Screws (65) and four
M10 Split Washers (22). Make sure that the Front					65	22
Stabilizer is turned so the Wheels (45) are not						22
Stabilizer is turned so the Wheels (45) are not
touching the floor.					22	1
					22	1
				45
						90
			5