NordicTrack NTEVEL59011 user manual Assembly

ASSEMBLY

Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two

included allen wrenches, assembly requires a phillips screwdriver			, an adjustable
spanner	, a rubber mallet	, and pliers	.

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 26. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 Split	M8 Washer (33)–2	M10 Split
Washer (58)–2			M10 Washer (63)–2
		Washer (22)–8
	M8 x 19mm Screw (30)–2		M10 Nylon Locknut (26)–5
M10 x 43mm Button Screw (97)–4
M10 x 56mm Button Screw (60)–4		M10 x 33mm Carriage Bolt (61)–2
	M10 x 85mm Bolt (25)–1

1. Identify the Rear Stabiliser (94), which has two	1		60
Levelling Feet (99) threaded into it. Turn the Rear
			60
Stabiliser so the Levelling Feet are closest to the rear
			22
of the Frame (1) as shown. Attach the Rear Stabiliser
to the Frame with the four M10 x 56mm Button Screws
(60) and four M10 Split Washers (22).			1
		22
			94
			99

5