ParaBody Hip Sled System manual Platform to Rotate Freely

Page 7

	44 1/2 X 5”
1	46
	46
	11
46	33
46
44 1/2 X 5”
FIGURE 2

STEP 2:

•Insert four 1/2” FLANGE BEARINGS (46) into the BUSHINGS on the BASE (1), and four 1/2” FLANGE BEARINGS (46) into the BUSHINGS on the PLATFORM (11) as shown in FIGURE 2.

•Assemble the PLATFORM (11) between the BUSHINGS on the BASE (1) as shown in FIGURE 2 using two 1/2 X 5” BOLTS (44) and two 1/2” LOCK NUTS (33). (TIGHTEN THE CONNECTION ENOUGH TO REMOVE THE PLAY, YET ALLOWING

THE PLATFORM TO ROTATE FREELY)

	STEP 3:	12
	• Attach four 1-1/2 X 3/4” PARAGLIDE STRIPS (27) to the end of
	the PLATFORM ADJUSTMENT (12), and four 1-1/2 X 3/4”
	PARAGLIDE STRIPS (27) to the end of the PLATFORM SLEEVE	27
	as shown in FIGURE 3 using the following steps:	27
	as shown in FIGURE 3 using the following steps:
	• Thoroughly clean all surfaces where the PARAGLIDE
	STRIPS (27) are to be attached.	27
		27

•Remove the PARAGLIDE STRIPS (27) from the paper backing and firmly apply them to all shown surfaces.

47

• SECURELY Assemble one 1/2” DIA. SPRING PIN (47) to the
SPRING PIN HOUSING, on the PLATFORM SLEEVE (2) as	2
shown in FIGURE 3. (!!! IMPORTANT !!! TIGHTEN THE	2
NUT OF THE SPRING PIN SECURELY)

FIGURE 3

7

Image 7