MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise cycle regularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries should be replaced. See assembly step 4 on page 5 for replacement instructions. If the console does not display your heart rate when you use the handgrip pulse sensor, see step 5 on page 13.
HOW TO LEVEL THE EXERCISE CYCLE
of the Crank (19) so that it is pointing toward the front of the exercise cycle, and then slide off the Left Side Shield.
Locate the |
|
| |
Reed Switch |
|
| |
(44). Turn the |
|
| |
Crank (19) |
|
| |
until the | 54 | 21 | |
Magnet (54) is | |||
| |||
|
| ||
aligned with |
|
| |
the Reed |
|
| |
Switch. |
| 44 | |
Loosen, but |
| ||
|
| ||
do not |
| 19 | |
remove, the |
| ||
|
| ||
indicated M4 |
|
|
x 16mm Screw (21). Slide the Reed Switch slightly closer to or away from the Magnet. Then, retighten the Screw. Turn the Left Crank Arm for a moment.
If the exercise cycle does not sit flat on the floor, turn one or both of the leveling pads until the exercise cycle is level.
Leveling 
Pads 
Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield and the left pedal.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the Drive Belt (64) may need to be adjusted. See HOW TO ADJUST THE REED SWITCH at the left. To adjust the Drive Belt, the Right Side Shield (5) must first be
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, remove the indicated M4 x 48mm Screws (20) and M4 x 16mm Screws (21) from the Left Side Shield (4). Using an adjustable wrench, turn the Left Pedal (40) clockwise and remove it. Turn the left side
removed. Remove the indicated M4 x 48mm Screws
(20)from the Left Side Shield (4) and the M4 x 16mm Screws (not shown) from the Right Side Shield. Using an adjustable wrench, turn the Right Pedal (not shown) counterclockwise and remove it. Next, turn the right side of the Crank (19) so that it is pointing toward the front of the exercise cycle, and then slide off the Right Side Shield.
19 | 4 | |
5 | ||
| ||
| 20 | |
40 |
| |
| 21 |
Next, turn the indicated M8 x 35mm Screw
(72)until the Drive Belt (64) is properly tightened. Then, reattach the right side shield and the right pedal.
64 |
72 |
20