10.Attach the Backrest (13) to the Seat Carriage (11) with four M6 x 38mm Hex Screws (68) and four M6 Washers (25).
11.Pull the seat knob and slide the Seat Carriage (11) onto the Seat Rail (7).
See the inset drawing. Hold the Bumper Axle (50) inside of the Seat Rail (7). Attach the two Bumpers (47) to the ends of the Bumper Axle with two M6 x 16mm Screws (70) and two M6 Washers (25) as shown. Press the Seat Rail Endcap (23) into the end of the Seat Rail.
12.Firmly tighten the four M8 x 31mm Button Screws
(69)in the Seat Carriage (11). Note: There are two Button Screws in each side.
Pull the seat knob and slide the Seat Carriage (11) to the desired position. Release the seat knob and slide the Seat Carriage back and forth slightly until it locks into position. Make sure to regularly tighten the four M8 x 31mm Button Screws (69).
13.Identify the Right Pedal (37), which is marked with an “R.” Using an adjustable wrench, firmly tighten the Right Pedal clockwise into the Pulley/Crank (19). Tighten the Left Pedal (not shown) counterclockwise into the Pulley/Crank on the left side. After using the exercise cycle for one week, retighten the Pedals.
Attach the Right Pedal Strap (38) to the Right Pedal (37), and press the end of the Right Pedal Strap onto the tab on the Right Pedal. Attach the Left Pedal Strap (not shown) in the same way.
10 |
|
|
|
|
|
|
|
|
| 13 | |
| 11 |
|
|
|
|
| 25 |
|
|
|
|
68 | 25 |
|
|
|
|
|
|
|
|
| |
11 |
| 70 | 47 | 7 |
|
|
|
|
|
| |
| 23 | 25 |
|
|
|
|
|
|
|
| |
|
|
|
|
| 47 |
|
|
| 50 | 25 | 70 |
|
|
|
|
| |
|
|
|
| 7 |
|
| 11 |
|
|
|
|
| Knob |
|
|
|
|
12 |
|
|
|
|
|
| 11 |
|
|
|
|
| 69 |
|
|
|
|
|
|
| Knob |
|
|
13 |
|
|
|
|
|
|
|
| 19 | 38 |
|
|
|
|
|
| 37 |
|
|
|
| Tab | |
14.Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat beneath the exercise cycle to protect the floor.
7