6.Connect the Pulse Wire (60) to the wire extending from the Console (9). Next, connect the Upper Wire Harness (16) to the wire harness on the Console. Insert all wires into the Handlebar Post (6).
Attach the Console (9) to the Handlebar Post (6) with four M4 x 16mm Screws (21). Be careful to avoid pinching the wires.
7.Attach the Water Bottle Holder (62) to the Handlebar Post (6) with two M4 x 22mm Screws (75). Note: The Water Bottle Holder is designed to be used with your own water bottle.
8.Attach the Seat (12) to the Seat Carriage (11) with four M6 x 16mm Hex Screws (29) and four M8 Flat Washers (18).
9.Identify the Right Seat Handle (79), which is marked with an “R” sticker.
Attach the Right Seat Handle (79) to the Seat Carriage (11) with two M8 x 19mm Button Bolts (43) and two M8 Nylon Locknuts (56) as shown.
Attach the Left Seat Handle (14) to the Seat Carriage (11) in the same way.
6
6 | 21 |
Console | |
Wires |
|
| 60 |
16 |
|
9 |
|
6 |
|
7 |
|
62 |
|
75 | 6 |
| |
8 |
|
| 12 |
11 |
|
18 |
|
29 |
|
| 29 |
9 |
|
14 |
|
| 79 |
11 |
|
56 | 43 |