Assembly

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench		and Phillips
screwdriver	.

Use the part drawings below to identify the small parts used in assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number fol- lowing the parentheses is the quantity needed for assembly. Note: Some small parts may have been preat- tached. If a part is not in the parts bag, check to see if it has been preattached.

M6 Washer	M8 Split	M4 x 16mm	M8 x 16mm Button	M8 x 19mm Button
		Round Head
(44)–7	Washer (55)–14	Screw (80)–4	Screw (54)–6	Screw (77)–4
M6 x 42mm Button		M6 x 38mm Button	M8 x 50mm Button
Screw (81)–4		Screw (72)–3		Screw (52)–4
		M10 x 63mm Bolt Set (62)–1

1.Orient the Left Front Stabilizer (15) with the Wheel (17) positioned as shown. Attach the Left Front Stabilizer to the left side of the Frame (1) with three M8 x 16mm Button Screws (54) and three M8 Split Washers (55).

Attach the Right Front Stabilizer (not shown) to the right side of the Frame (1) in the same way.

1
17		15
	55	55	1
	55	54
	54	54
	54