20.Turn the Seat (14) as shown. Attach the wide end of the Seat to the bracket on the Seat Mounting Bracket (23) with two M6 x 16mm Screws (3).
Tilt the Seat Mounting Bracket (23) upwards and attach the narrow end of the Seat (14) to the Seat Mounting Bracket with an M6 x 35mm Bolt (34) and an M6 Washer (30).
21.Attach the Adjustable Bench Leg (2) to the Bench Leg (1) with the Adjustment Knob (37).
Insert a 45mm Square Inner Cap (40) into the top of the Adjustable Bench Leg (2).
22.Insert three 45mm Square Inner Caps (40) into the ends of the Leg Lever (17). Insert a 25mm Round Inner Cap (39) into the weight tube on the Leg Lever. Press a 25mm Angled Outer Cap (38) onto the other end of the weight tube.
Attach the Leg Lever (17) to the Adjustable Bench Leg (2) with an M10 x 70mm Bolt (21) and an M10 Nylon Locknut (11). Note: Do not over tighten the
M10 Nylon Locknut; the Leg Lever must pivot easily.
23.Insert 19mm Round Inner Caps (26) into the ends of the three Pad Tubes (16).
Insert two Pad Tubes (16) through the holes in the Leg Lever (17). Slide a Foam Pad (25) onto each side of the Pad Tubes.
Insert a Pad Tube (16) through the upper tube on the Adjustable Bench Leg (2). Slide a Foam Pad (25) onto each side of the Pad Tube.
12
20 |
|
|
|
| 14 |
|
|
Bracket |
|
| |
| 23 |
|
|
|
| 30 |
|
|
| 3 |
|
| 34 |
|
|
21 | 40 |
|
|
|
|
| |
|
| 2 |
|
| 37 |
|
|
| 1 |
|
|
22 |
|
|
|
|
| 21 |
|
40 | 2 |
| |
|
|
| |
Weight | 40 | 11 | |
| |||
|
| ||
Tube |
|
| |
39 |
| 38 |
|
| 17 |
| |
| 40 |
| |
|
|
| |
23 | 26 |
|
|
| 25 | 2 |
|
25 |
|
|
|
|
| 16 |
|
26 |
|
|
|
| 25 |
| 25 |
|
|
| |
| 17 |
|
|
|
| 25 | 26 |