3.Slide a Brace (44) onto the bracket on one of the Uprights (43). Attach the Brace to the Upright with two M10 x 65mm Bolts (68), four M10 Washers (6), and two M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.
Slide the Upright (43) and the Brace (44) onto the M10 x 65mm Carriage Bolts (66) and the M8 x 65mm Carriage Bolts (71) in the left Base (46). Attach the Upright with two M10 Nylon Locknuts (11). Attach the Brace with two M8 Washers (77) and two M8 Nylon Locknuts (42). Do not tighten the Nylon Locknuts yet.
Repeat this step on the right Base (46) with the other Upright (43) and Brace (44).
4.Press a 25mm Round Inner Cap (39) into the end of a Weight Storage Tube (55).
While a second person holds the Middle Crossbar
(47)in the position shown, insert two M10 x 70mm Bolts (21) through the bracket on the Weight Storage Tube (55), the left Brace (44), and the bracket on the Middle Crossbar. Thread an M10 Nylon Locknut (11) onto each Bolt. Do not tighten the Nylon Locknuts yet.
5.Press a 25mm Round Inner Cap (39) into the end of the other Weight Storage Tube (55).
While a second person continues to hold the Middle Crossbar (47), insert two M10 x 70mm Bolts (21) through the bracket on the Weight Storage Tube (55), the right Brace (44), and the bracket on the Middle Crossbar. Thread an M10 Nylon Locknut (11) onto each Bolt. Do not tighten the Nylon Locknuts yet.
7
3 |
|
|
|
|
|
| 43 |
|
|
|
| 11 6 |
|
|
|
|
| 44 |
|
|
| 6 | 68 |
|
|
|
|
| |
|
| Bracket | 42 | |
|
|
|
| 77 |
|
| 11 |
|
|
|
|
| 71 |
|
|
|
| 46 |
|
|
| 66 |
|
|
4 |
|
|
|
|
|
|
| 44 |
|
| 47 |
|
|
|
|
|
| 55 |
|
|
| 11 |
| 21 |
|
|
| 21 | 39 |
5 | 39 | 21 |
|
|
|
|
|
| |
|
| 55 |
|
|
| 21 |
|
|
|
| 44 |
| 47 |
|
|
|
|
| |
|
| 11 |
|
|