Image IMBE53900 manual Pull-up Bar Round tube

6.Have a second person hold the Top Crossbar (48) so that the pull-up bar faces away from the rack, as shown.

Attach the Top Crossbar (48) to the left Upright (43) with two M10 x 70mm Bolts (21), a Small Support Plate (51), and two M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.

Attach the Top Crossbar (48) to the right Upright (43) with two M10 x 70mm Bolts (21), a Small Support Plate (51), and two M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.

7.Press a 25mm Bushing (73) into each end of the Locking Bar (62).

Insert the Barbell (63) through the Locking Bar (62) until the Barbell is centered in the Locking Bar.

8.Identify the Left Weight Glider (60) by looking at the position of the round tube.

Press a 38mm Bushing (58) into each end of the round tube on the Left Weight Glider (60).

Slide the Left Weight Glider (60) onto the left end of the Barbell (63). Secure the Weight Glider to the Barbell with a hand-tightened M8 x 16mm Bolt (75).

Look at the drawing on page 4 to make sure that you have correctly identified the left end. The Left Weight Glider must be turned as shown in the drawing.

Repeat this step with the Right Weight Glider (not shown).

8

6
21	11
51		48
	11		11
21
	Pull-up
	Bar	11
			51
			21
	43
			43
			21
7
73	62
			63
			73
8
		58	60
63			75
			58

Round tube