17.Press a 3” x 2” Outer Cap (56) onto each end of the Stabilizer (58).
Attach the Stabilizer (58) to the Bench Frame (52) with two 3/8” x 2 3/4” Button Head Bolts (57) and two 3/8” Nylon Lock Jamnuts (29).
18.Press a 2” Square Outer Cap (65) onto each end of the Bench Base (53).
Attach the Bench Base Joint Plate (64) to the Bench Base (53) with two 3/8” x 3” Bolts (34), two 3/8” Washers (37), and two 3/8” Nylon Lock Jamnuts (29).
Attach the Bench Leg (48) to the Bench Base Joint Plate (64) with two 3/8” x 3” Bolts (34), two 3/8” Washers (37), and two 3/8” Nylon Lock Jamnuts (29).
19.Attach the Bench Leg (48) to the Bench Frame (52) with two Bench Joint Plates (63), four 3/8” x 3” Bolts (34), and four 3/8” Nylon Lock Jamnuts (29).
20.Press two 1” x 1 1/2“ Inner Caps (72) into each Backrest Tube (71).
Lubricate a 3/8” x 7 1/2” Bolt (66). Attach the Backrest Tubes (71) to the welded tube on the Backrest Adjustment Bracket (79) with the Bolt and a 3/8” Nylon Lock Jamnut (29). Make sure that the
Backrest Tubes are turned as shown. The indicat- ed holes are not centered in the Backrest Tubes but are closer to one side. Turn the Backrest Tubes so the holes are closer to the floor. Do not overtighten the Nylon Lock Jamnut; the Backrest Tubes must pivot easily.
17 |
|
| 29 |
|
|
| |
| 56 |
| 58 |
| 52 |
|
|
|
|
| 57 |
|
|
| 56 |
18 |
|
|
|
| 37 |
| 48 |
|
|
| |
| 34 |
|
|
| 53 | 37 | 29 |
|
| ||
65 | 37 |
| 64 |
| 34 | 37 |
|
|
|
| |
| 65 |
|
|
19 |
|
|
|
34 |
| 63 |
|
|
|
| |
|
|
| 52 |
|
|
| 63 |
| 48 | 29 | |
|
|
| |
20 | Lubricate | 71 | 72 |
66 |
|
|
|
Holes |
|
| 29 |
72 |
|
| 79 |
|
|
| |
| Welded |
|
|
| Tube |
|
|
11 |
|
|
|