Image IMBE39401 user manual Make sure that the Backrest Tubes are turned as

17.Press a 51mm x 76mm Outer Cap (56) onto each end of the Stabilizer (58).

Attach the Stabilizer (58) to the Bench Frame (52) with two M10 x 58mm Carriage Bolts (57) and two M10 Nylon Locknuts (29). Attach the Stabilizer so that the warning decal is in the position shown.

Note: Do not tighten the Nylon Locknuts yet.

18.Press a 50mm Square Outer Cap (65) onto each end of the Bench Base (53).

Attach the Bench Base Joint Plate (64) to the Bench Base (53) with two M10 x 68.5mm Bolts (75), two M10 Washers (37), and two M10 Nylon Locknuts (29).

Attach the Bench Leg (48) to the Bench Base Joint Plate (64) with two M10 x 68.5mm Bolt (75), two M10 Washers (37), and two M10 Nylon Locknuts (29). Be sure the welded nut is in the position shown.

Note: Do not tighten the Nylon Locknuts yet.

19.Attach the Bench Leg (48) to the Bench Frame (52) with two Bench Joint Plates (63), four M10 x 72mm Bolts (34), and four M10 Nylon Locknuts (29).

Note: Tighten all the M10 Nylon Locknuts (29) used in steps 17-19.

20. Press two 25mm x 38mm Inner Caps (72) into each

Backrest Tube (71). Press two 25mm x 38mm Inner

Caps into the Backrest Adjustment Bracket (79).

Lubricate a M10 x 192mm Bolt (66). Attach the

17			29
	56		Decal
	52
		58
			57
			56
18			Welded Nut
	37		48
	75
	53	37	29
65	37		64
	75	37
	65
19
34		63
			52
			63
	48		29
20	Lubricate	71	72
66	37

Backrest Tubes (71) to the welded tube on the

Backrest Adjustment Bracket (79) with the Bolt, two

M10 Washers (37) and a M10 Nylon Locknut (29).

Make sure that the Backrest Tubes are turned as

Holes

37

29

shown. The indicated holes are closer to one

side. Turn the Backrest Tubes so the holes are

closer to the floor. Do not over tighten the Nylon

Locknut; the Backrest Tubes must pivot easily.

7279

Welded

Tube72

11