21.Lubricate a M10 x 192mm Bolt (66). Attach the Backrest Tubes (71) to the welded tube on the Bench Frame (52) with the Bolt, two M10 Washers (37), and a M10 Nylon Locknut (29). Note: Do not over tight- en the Nylon Locknut; the Backrest Tubes must pivot easily.
22.Attach the Backrest (60) to the Backrest Tubes (71) with four M6 x 52mm Screws (51) and four M6 Washers (74).
23.See the inset drawing. Press the 20mm x 40mm Inner Cap (77) into the open end of the Seat Mounting Bracket (67).
See the inset drawing. Lubricate a M10 x 68.5mm Bolt (75). Attach the Seat Adjustment Bracket (80) to the indicated side of the Seat Mounting Bracket (67) with the Bolt and a M10 Nylon Locknut (29). Note: Do not over tighten the Nylon Locknut; the Seat Adjustment Bracket must pivot easily.
Place the Seat Mounting Bracket (67) on the Bench Frame (52) so that the Seat Adjustment Bracket (80) fits over the welded pin on the side of the Bench Frame.
Lubricate a M10 x 72mm Bolt (34). Attach the Seat Mounting Bracket (67) to the indicated bracket on the Bench Frame (52) with the Bolt and a M10 Nylon Locknut (29). Note: Do not over tighten the Nylon
Locknut; the Seat Mounting Bracket must pivot easily.
24.Turn the Seat (59) as shown. Attach the wide end of the Seat to the bracket on the Seat Mounting Bracket (67) with two M6 x 16mm Screws (50).
Tilt the Seat Mounting Bracket (67) upwards and attach the narrow end of the Seat (59) to the Seat Mounting Bracket with a M6 x 35mm Screw (78) and an M6 Washer (74).
21 | Lubricate |
|
|
|
|
| |
| 37 |
|
|
| 66 |
|
|
| 71 |
|
|
Welded Tube | 37 | 29 | |
|
|
| |
| 52 |
|
|
22 |
|
|
|
| 60 |
|
|
|
|
| 71 |
| 74 |
|
| 51 |
|
23 | 67 |
|
Lubricate | 80 |
|
34 | Lubricate |
|
| 67 | |
Welded | 80 | |
Pin | 75 |
|
|
| |
| 52 |
|
| 29 | 29 |
| 77 | |
24 |
|
|
59 |
|
|
Bracket |
| |
67 |
| |
| 74 |
|
| 50 |
|
| 78 |
|
12