14.Insert a 2” Square Inner Cap (28) into the end of a Butterfly Arm (10).
Attach a Butterfly Handle (53) to the Butterfly Arm
(10)with two 3/8” x 1” Bolts (84) and two 3/8” Flat Washers (48).
Repeat this step with the other Butterfly Arm (10).
15.Lubricate a 3/8” x 3 1/4” Bolt (62). Attach the left Butterfly Arm (10) to the Left Pivot Arm (71) with the Bolt and a 3/8” Nylon Locknut (50).
Repeat this step with the right Butterfly Arm (not shown) and the Right Pivot Arm (85).
16.Lubricate a 1/2” x 4” Bolt (68). Attach the Press Frame (8) to the Press Base (6) with the Bolt and a 1/2” Nylon Jamnut (36). Note: Be sure the Press
Frame is oriented with the indicated hole closer to the Press Upright (2). Do not over tighten the 1/2” Nylon Jamnut; the Press Frame must be able to pivot easily.
17.Insert a 2” Square Inner Cap (28) into the top of a Press Arm (77). Press two 1” Round Inner Caps
(86)into the outside ends of the handles.
Attach the Press Arm (77) to the Press Frame (8) with two 5/16” x 2 3/4” Bolts (96) and two 5/16” Nylon Locknuts (64).
Repeat this step with the other Press Arm (77).
10
14 |
| |
| 10 | |
48 | 48 | |
53 | ||
10 | ||
53 | 84 | |
| ||
48 | 28 | |
48 | ||
28 |
| |
15 | 50 | |
| ||
| 10 | |
85 | 71 | |
Lubricate 62 | ||
| ||
16 |
| |
8 |
| |
| 2 | |
| Hole | |
68 |
| |
| 6 | |
| 36 | |
Lubricate | ||
17 | 28 | |
Handles | 86 | |
| ||
| 64 | |
96 | 77 | |
8 |
| |