11.Secure the Press Top Frame (9) to the Butterfly Top Frame (33) with two 3/8” x 3 1/4” Bolts (62), two 3/8” Flat Washers (48), and two 3/8” Nylon Locknuts (50). Do not tighten the Nylon Locknuts yet.
12.Secure the Weight Guides (15) to the Press Top Frame (9) with two 3/8” x 1 3/4” Bolts (57) and two 3/8” Nylon Locknuts (50).
Tighten the Nylon Locknuts used in steps 2–12.
ARM ASSEMBLY
13.Locate and open the parts bag labeled “ARM ASSEMBLY.”
Press a 1 1/2” Square Inner Cap (35) into the back of the Right Pivot Arm (85). Lubricate the axles on the Butterfly Top Frame (33). Secure the Right Pivot Arm to the right axle with two Retainer Rings (31) and a 1” Round Outer Cap (38). Do not confuse the Right Pivot Arm with the Left Pivot Arm (not shown).
Note: Be sure the Retainer Rings (31) and 1” Round Outer Cap (38) are oriented as shown in the inset drawing. The Retainer Rings may break if disassembled.
Repeat this step with the Left Pivot Arm (not shown) and left axle.
11 |
|
|
| 50 | 62 |
| 48 | |
| 9 | 48 |
|
| |
|
| 33 |
12 | 57 |
|
|
| |
| 9 |
|
| 50 | 50 |
| 15 |
|
13 |
|
|
|
| 33 |
|
| Lubricate |
|
| 85 |
| 35 | 31 |
|
| |
| Axle | 38 |
|
| |
31 |
|
|
| 38 |
|
9