22.Remove the preassembled 3/8” x 2” Bolts (54) from one set of Adjustable Pulley Plates (23).
Wrap the Butterfly Cable (73) around a 3 1/2” Pulley (24). Attach the Pulley and a Cable Trap (25) between the top holes of the Adjustable Pulley Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8” Nylon Locknut (50). Be sure that the Cable Trap is turned to hold the Cable in place.
23.Wrap the Butterfly Cable (73) around a
(50). Be sure that the Cable Trap is turned to hold the Cable in place.
24.Secure a 3/8” x 2 1/4” Bolt (79) to the Left Pivot Arm (71) with a 3/8” Nylon Jamnut (63).
Attach the Butterfly Cable (73) to the 3/8” x 2 1/4” Bolt (79) with a 3/8” Nylon Jamnut (63). Note: Do not fully tighten the Nylon Jamnut; the Butterfly Cable must be able to pivot easily.
25.Locate the Ab Cable (47). Insert the Ab Cable up through the Press Top Frame (9) and wrap it around a 3 1/2” Pulley (24). Attach a 3/8” Flat Washer (48) and a 5/8” x 3/4” Bushing (66) to a 3/8” x 3 1/4” Bolt (62). Slide the Bolt through the Press Top Frame and the Pulley. Secure another 5/8” x 3/4” Bushing and 3/8” Flat Washer to the Bolt with a 3/8” Nylon Locknut (50).
12
22 |
| |
54 | 24 | |
25 | ||
| 73 | |
| 50 | |
23 | ||
23 | 87 | |
| ||
32 |
| |
50 | 27 | |
| ||
| 73 | |
| 1 | |
24 |
| |
73 |
| |
| 63 | |
| 71 | |
| 79 | |
25 |
| |
66 |
| |
24 |
| |
62 | 9 | |
48 | ||
| ||
48 | 50 | |
47 |
| |