Image 8.0 user manual TROUBLE-SHOOTING and Maintenance, Tightening the Cables

Page 24

TROUBLE-SHOOTING AND MAINTENANCE

Make sure that all parts have been properly tightened each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened.

To tighten the cables, first insert the weight pin into the middle of the weight stack. Slack can be removed from these cables several ways:

See drawing 1. Loosen the 1/2” Plain Nut (100) on the

1

Weight Cable (72) bolt, away from the 1/2” Flat Washer

72

(11). Screw the bolt a few turns into the Weight Tube

(17). Retighten the 1/2” Plain Nut down onto the 1/2” Flat

100

Washer.

11

 

 

17

See drawing 2. Remove either the upper or lower 3/8”

2

Nylon Locknut (50) and 3/8” x 2” Bolt (54) from the

 

Adjustable Pulley Plates (23). Remove the 3 1/2” Pulley

23

(24) and the Cable Trap (25). Reattach the 3 1/2” Pulley

and the Cable Trap to a hole closer to the center of the

54

 

Adjustable Pulley Plates with the 3/8” x 2” Bolt and 3/8”

25

Nylon Locknut.

50

 

Either set of Adjustable Pulley Plates (23) can be adjust-

24

ed in this manner.

 

Do not over tighten the cables. If the cables are over tightened, the top weight will be lifted off the weight stack.

If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and re-install it.

If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

24

Image 24
Contents QUESTIONS? Model No. IMSY59300 Serial NoCustomer HOT Line Table of Contents Limited WarrantyImportant Precautions Before YOU Begin For your benefit, read this manual carefully beforeDecal Assembly Make Assembly EasierFrame Assembly Nylon Locknuts yetDo not tighten the Nylon Locknuts yet Large Pin Groove Locate and open the parts bag labeled ARM Assembly Tighten the Nylon Locknuts used in stepsPage Cable Assembly Page Page Weight Cable is in the groove of the Pulley Page Page Locknut yet Page Seat Assembly Locate and open the parts bag labeled Seat AssemblyPage Adjustments Changing the Weight SettingAttaching the LAT BAR or AB Strap to High Pulley Station Adjusting the Backrest Adjusting the Curl PADAttaching the AB Strap to the AB Pulley Station Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams Weight Cable Cable ID Stack Low Pulley Part Identification CHART-Model No. IMSY59300 R0801A X 4 Bolt X 4 3/4 Bolt X 5 1/2 Bolt 2 Square Inner Cap 3 Inner Cap 2 x 2 1/2 Inner Cap Part LIST-Model No. IMSY59300 Key No. Qty DescriptionExploded Ordering Replacement Parts