19.Lubricate an M10 x 180mm Bolt (22). Attach the Backrest Tubes (27) to the indicated tube on the Bench Frame (5) with the Bolt, two M10 Washers (6), and an M10 Nylon Locknut (11). Note: Do not over tighten the Nylon Locknut; the Backrest Tubes must pivot easily.
20.Attach the Backrest (15) to the Backrest Tubes (27) with four M6 x 55mm Bolts (4) and four M6 Washers (30).
21.Press a 25mm x 50mm Inner Cap (58) into the open end of the Seat Support Tube (37).
Lubricate an M8 x 80mm Bolt (9). Attach the Seat Adjustment Bracket (45) to the indicated side of the Seat Support Tube (37) with the Bolt and an M8 Nylon Locknut (54). Note: Do not over tighten the
Nylon Locknut; the Seat Adjustment Bracket must pivot easily.
22.Place the Seat Support Tube (37) on the Bench Frame (5) so that the Seat Adjustment Bracket (45) fits over the welded pin (not visible in the drawing) on the side of the Bench Frame.
Lubricate an M10 x 80mm Bolt (56). Attach the Seat Support Tube (37) to the indicated bracket on the Bench Frame (5) with the Bolt and an M10 Nylon Locknut (11). Note: Do not over tighten the Nylon
Locknut; the Seat Support Tube must pivot easily.
19 | Lubricate |
|
|
| |
|
| 6 |
|
| 27 |
22 |
|
|
|
| |
|
|
|
|
| |
| 5 |
|
|
|
|
|
| Tube |
| 6 | 11 |
|
|
|
|
| |
20 |
|
|
|
|
|
| 15 |
|
|
|
|
|
|
|
|
| 27 |
|
|
|
|
| 30 |
|
|
|
|
| 4 |
| 30 |
|
| 30 |
|
|
|
|
|
| |
|
| 4 |
|
|
|
21 | 9 |
|
|
|
|
|
|
|
|
| |
|
| 45 |
|
| 37 |
|
|
|
|
| |
Lubricate |
|
|
|
| |
| 58 |
|
|
| 54 |
22 | 37 |
|
|
|
|
|
|
|
|
| |
|
|
| Lubricate | ||
| 45 | 56 |
|
|
|
|
|
|
|
| |
| Welded |
|
|
|
|
| Pin |
|
|
|
|
|
|
| 5 |
| 11 |
|
|
|
|
| |
12