Assembly
2.Locate the tight upright. Connect the console harness together. One side of har- ness is located near the motor cover on the bottom right side. The other end is located inside the right upright.
Connect the amplifier harness together. One side of harness is located near the motor cover on the bottom right side.
The other end is located inside the right upright.
Note: Make sure that the console harness and the amplifier harness are inside of the upright and not being pinched.
Slide the left upright onto the base frame.
Secure the left upright to the base frame by using four bolts M10x25 and four wash-
ers #10.
Bolt M10x25
Washer #10 |
|
Console | Amplifier |
Harness | |
| Harness |
4.Locate the cross bar. Slide the cross bar in between the left and right uprights. Secure the cross bar using one washer #8 and one bolt M8x52 on the right side and one washer #8 and one bolt M8x26 on the left side.
Figure 3: Right Upright Installation
Washer #8 |
|
Crossbar |
|
Bolt M8x26 | Bolt M8x52 |
|