JVC LVT1364-002B manual Specifications

Page 29

Specifications

Design and specifications are subject to change without notice.

Amplifier Section

Output Power:

25 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more than 10% total harmonic distortion. (IEC268-3)

Audio input sensitivity/Impedance (at 1 kHz) AUX: 500 mV/50 kΩ

Speakers Impedance:

4 Ω – 16 Ω

Tuner

FM tuning range:	87.50 MHz – 108.00 MHz
AM (MW) tuning range: 522 kHz – 1 629 kHz

CD player

Dynamic range:	85 dB
Signal-to-noise ratio:	85 dB
Wow and flutter:	Immeasurable

Cassette deck

Frequency response:

Normal (type I):	100 Hz – 10 000 Hz
Wow and flutter:	0.35% (WRMS)

General

Power requirement:	AC 230 V , 50 Hz
Power consumption:	52 W (at operation)

1.5W (on standby)

Dimensions (W/H/D) (approx.):

	152 mm x 233 mm x 331 mm
Mass (approx.):	4.5 kg

Supplied accessories

See page 6.

Speaker Section

Type:	Full range, bass-reflex type
Speakers:	10 cm cone x1
Power handling capacity: 25 W
Impedance:	4 Ω
Frequency range:	100 Hz – 15 kHz
Dimensions (W/H/D) (approx.):
	152 mm x 233 mm x 188 mm
Mass (approx.):	1.8 kg each

26

Image 29

Contents UX-G4 UX-G3 Important for Laser Products Above ALL About This Manual PrecautionsIntroduction Contents Main Unit Location of the Buttons and ControlsTop view Front viewMain unit Display window Display windowPreset Group /UP, Preset Group /DOWN Remote ControlConnecting Speakers Connecting AM MW and FM AntennasGetting Started UnpackingPutting the Batteries into the Remote Control Connecting Other EquipmentTo remove the speaker grilles To connect an audio equipmentTurning On the Power Setting the ClockCommon Operations Turning Off the Unit Automatically Auto StandbySelecting the Source Adjusting the VolumeSelecting the Sound Modes Reinforcing the Bass SoundPlaying Back the Entire Disc-Normal Play Playing Back DiscsPress Open on top of the unit Place a disc correctly with its label side upBasic Disc Operations Programming the Track Playing Order -Program PlayPress CD 3/8 Repeating Tracks-Repeat PlayPlaying at Random-Random Play On the remote control only Press RandomDisplaying the Remaining Time during Playback Press Remain repeatedlyPlaying Back a Tape Playing Back TapesListening to FM and AM MW Broadcasts Tuning in to a StationPresetting Stations Changing the RDS Information Tuning in to a Preset StationReceiving FM Stations with RDS Press ¢ or 4 or UP ¢ or Searching for Programs by PTY Codes PTY SearchDown 4 on the unit If no program is found, no MatchSet the volume level to the minimum position Press AUX Using an External EquipmentListening to the External Equipment For operation of the external equipmentRecording To record on both sides-Reverse ModeRecording on a Tape Press REC recordingRecording Discs Disc Synchronized Recording When making Sleep Timer settings while RecordingPlayback Repeatedly until Is litUsing Daily Timer and Recording Timer Using the TimersActivate-Daily 1, Daily 2, Daily 3, or Rec Set the on-time you wantPress and hold Daily TIMER/ Snooze on the unit Using Snooze TimerPress STANDBY/ON to turn Off the unitHow the Sleep Timer actually works Using Sleep TimerOn the remote control only Press Sleep Cleaning the unit MaintenanceHandling discs Handling cassette tapesPossible Cause Action TroubleshootingSymptom Specifications UX-G4/UX-G3 Micro Component System