JVC MX-DVA5 manual Listening to FM and AM Broadcasts, Press and hold Áor

English

Listening to FM and AM Broadcasts

Tuning in a Station

1 Press FM/AM.

The unit automatically turns on and tunes in the previously tuned station (either FM or AM).

On the unit ONLY:

1 Tune in the station you want to preset.

• See “Tuning in a Station” on the left column.

• Each time you press the button, the band alternates between FM and AM.

2 Start searching for stations.

On the unit:

Press and hold TUNING + or

TUNING – for more than 1 TUNING

2

3

Press SET.

Press PRESET + or PRESET – to select a preset

SET

PRESET

NEXT

second.

On the remote control:

Press and hold Áor

1for more than 1 second.

number.

PREV.

The unit starts searching stations and stops when a station of sufficient signal strength is tuned in.

•If a received program is broadcast in stereo, the ST (stereo) indicator lights up.

To stop during searching, press TUNING + or TUNING – (Áor 1 on the remote control).

When you press TUNING + or TUNING – (orÁor 1 on the remote control) briefly and repeatedly

The frequency changes step by step.

To change the FM reception mode

When an FM stereo broadcast is hard to receive or noisy, press FM MODE/SLOW on the remote control so that “MONO” appears and the MONO indicator also lights up on the display. Reception improves.

To restore the stereo effect, press FM MODE/SLOW again so that “STEREO” appears on the display and the MONO indicator goes off from the display.

In this stereo mode, you can hear stereo sounds when a program is broadcast in stereo.

4	SET
	Press SET again.

The tuned station in step 1 is stored in the preset number selected in step 3.

•Storing a new station on a used number erases the previously stored one.

When you unplug the AC power cord or if a power failure occurs

The preset stations will be erased in a few days. If this happens, preset the stations again.

Tuning in a Preset Station

1 Press FM/AM.

The unit automatically turns on and tunes in the previously tuned station (either FM or AM).

• Each time you press the button, the band alternates between FM and AM.

Presetting Stations

You can preset 30 FM and 15 AM stations.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

2 Select a preset number.

On the unit:
Press PRESET + or
PRESET –.	PREV.

On the remote control:

Press the number buttons.

Ex.: For preset number 5, press 5. For preset number 15, press 10, then 5. For preset number 20, press 10 twice (and wait for a few seconds.) For preset number 30, press 10 three times (and wait for a few seconds.)

PRESET

/

NEXT

– 13 –