Assembly

To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the

included tools and your own adjustable wrench and Phillips screwdriver .

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled.

If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 Nylon	M10 Nylon	M8 Curved	M8 Split	M4 x 16mm	M4 x 22mm
Locknut (10)–6	Locknut (33)–4	Washer (57)–2	Washer (41)–10	Screw (49)–4	Screw (20)–2
M8 x 25mm Button	M8 x 45mm Button		M10 x 75mm Carriage Bolt (30)–4
Screw (45)–6	Screw (9)–2

1.Identify the Front Stabilizer (2). See the inset drawing. Attach a Wheel (14) to one end of the Front Stabilizer with an M8 Nylon Locknut (10). Make sure that the

Wheel is oriented as shown and that it turns freely. Next, align the four plastic posts on a Wheel Cover (23) with the plastic posts on the Wheel, and press the Wheel Cover onto the Wheel. Assemble the other Wheel (not shown) in the same way.

While another person lifts the front of the Frame (1), attach the Front Stabilizer (2) to the Frame with two M10 x 75mm Carriage Bolts (30) and two M10 Nylon Locknuts (33) as shown.

1	1
	1
2
		33
		14	2
		14
30	23	10
30
			Post