4.Raise the Upright (3). Slide the M10 Flat Washer
(94)onto the Patch Bolt (90). Secure the Upright by tightening the Patch Bolt (90) into the Base Frame
5.Thread the Long Extension Wire (100) through the indicated hole in the Console Plate (101). Attach the Console Plate to the Upright (3) with four Console Plate Screws (39) and four M10 Split Washers (73).
Make sure that the Long Extension Wire is not pinched between the Upright and the Console Plate.
6.Connect the Long Extension Wire (100) to the corre- sponding wire on the Console (97).
Next, connect the two Console Plate Wires (106) to the two corresponding wires on the Console (97). Note: Either Console Plate Wire can be attached to either wire on the Console.
Next, attach the ground wire to the indicated hole in the Console Plate (101) with an M4 x 16mm Screw (60).
7.Carefully feed all wires down through the Console Plate (101). Attach the Console (97) to the Console Plate with four M4 x 16mm Screws (60). Be careful to avoid pinching the wires.
Refer to the inset drawing. Tap the Water Bottle Holders (87) into the indicated holes in the Console Plate (101).
6
4 |
|
|
| 3 |
|
90 | 94 |
|
|
| 1 |
5 |
|
|
| 101 |
|
| 100 |
|
73 |
| 3 |
|
| |
39 |
|
|
6 |
| 97 |
|
| |
| Console |
|
| Wires |
|
| 106 | 60 |
|
| Ground |
|
| Wire |
|
| 100 |
| 101 |
|
7 |
|
|
|
| 97 |
101 |
|
|
|
| 87 |
60 |
| 101 |