4.Attach the Handlebar (16) to the Upright (6) with three M8 x 45mm Button Screws (17) and three M8 Curved Washers (28). Make sure that the Pulse Wires (22) are not caught between the Handlebar and the Upright.
5.The Console (9) requires two ÒAAÓ batteries (not included); alkaline batteries are recommended. Refer to drawing A. Remove the four indicated screws and lift off the front of the Console. Press two batteries into the battery holder as shown in drawing B. Make sure that the negative (Ð) ends of the bat- teries are touching the springs. Reattach the front of the Console. Make sure that the three wires are extending from the back of the Console.
While another person holds the Console (9) near the Upright (6), connect the two Pulse Wires (22) to the corresponding wires on the Console. Next, plug the Extension Wire (18) into the back of the Console.
Attach the ground wire and the Console (9) to the Upright (6) in the following way:
¥Peel the backing off one side of the
¥Peel the backing off the other side of the Tape (81). Slide a Star Washer (80) onto a Console Screw
(20)and push the Screw up through the Tape and the indicated hole. Next, slide another Star Washer
(80)and the ground wire onto the Screw.
¥Set the Console (9) on the Upright (6) and tighten the Console Screw (20) into the Console. Then, tighten three additional Console Screws (20) into the Console and the Upright.
6.Attach the Cup Holders (14) by firmly pushing them down into the indicated holes in the Upright (6) until they are seated fully.
4 |
|
|
22 | 28 | |
| ||
16 |
|
|
|
| 17 |
|
| 6 |
5 |
|
|
Console | 9 | |
Wires |
|
|
Ground |
|
|
Wire |
|
|
22 |
|
|
Hole |
|
|
6 |
| 80 |
81 |
| 18 |
80 |
|
|
20 |
| A |
20 |
| |
|
| |
B | Battery | |
| ||
| Holder | |
Batteries |
| Screws |
6 |
| 14 |
|
| 6 |
14 |
|
|
7