ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools (not included) are required for assembly: a phillips screwdriver 
, an
adjustable wrench 
, and a rubber mallet 
.
1.Lay a cloth over the front of the Frame (1) to protect it. Lay the Upright (2) in the position shown. Connect the Extension Wire (51) to the Wire Harness (57).
2.Align the two holes in the front of the Upright (2) with the two welded bolts on the front of the Frame (1). Carefully push the Wire Harness (not shown) into the Upright until there is no slack.
Next, pivot the Upright (2) about halfway to the vertical position while guiding the Wire Harness (not shown) into the Upright. Pivot the Upright to the vertical posi- tion so it rests on the four welded bolts on the Frame
(1). Be careful to avoid pinching the wires.
Lift the front of the Incline Frame (5). Tighten a 3/8Ó Nylon Locknut (26) onto each welded bolt.
3.Attach the Console (87) to the Console Base (49) with four Zinc #8 x 1/2Ó Screws (35), making sure that the indicated wires are extending from the Console Base (49). Be careful not to pinch the wires.
1 | 2 |
| 51 |
|
|
| 57 |
| 1 |
|
|
2 |
|
|
|
|
| 26 | 2 |
|
|
| |
|
|
| 26 |
| 5 |
|
|
| 1 |
|
|
3 |
|
| 87 |
|
|
| |
| 49 |
|
|
| Wires |
|
|
|
|
| 35 |
5