Healthrider E 530 manual Pinching the wires, Upper Body Arms are turned as shown. Tap another

4. Connect the Extension Wire (51) to the corresponding	4
wire on the Console (87).
Next, connect the two Pulse Wires (86) to the two				87
		Console
remaining wires on the Console (87). Note: Either
			Wires
Pulse Wire can be attached to either wire on the				49
Console.
Next, connect the ground wire to the indicated hole in			86	35
the Upright (2) with a Zinc #8 x 1/2Ó Screw (35) and				57
the #8 Star Washer (53).				Ground Wire
				53
Carefully feed the wires down into the Upright (2).				35
Attach the Console Base (49) to the Upright with four
Zinc #8 x 1/2Ó Screws (35). Be careful to avoid
pinching the wires.
		35	2
5. Refer to the inset drawing. Apply a small amount of the	5
included lubricant to a paper towel; rub a thin film of
				7
lubricant onto the Chrome Extension Tube (21) on the
Right Pedal Arm (4). Slide the Chrome Extension Tube
into one of the Upper Body Arms (7).
Slide the other Chrome Extension Tube (21) into the				21
other Upper Body Arm (7) in the same way.				85
				Lube
Tap a 5/8Ó Axle Cap (85) onto one end of the Axle (19).				4
Insert the Axle through one of the Upper Body Arms
				19
(7) and then through the Upright (2). It may be helpful
to tap the Axle with a rubber mallet. Slide the other	85			7
Upper Body Arm (7) onto the Axle. Make sure that the
Upper Body Arms are turned as shown. Tap another
5/8Ó Axle Cap (85) onto the Axle.
	7		2
6. Plug the Power Supply (96) into the jack at the rear of	6
the elliptical crosstrainer. Note: Your Power Supply
may look different from the one pictured.
				Jack
				96

7.Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: There may be some hardware left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.

6