JVC LVT0954-007A manual Using the Recording Timer, How the Recording Timer actually works

English

Three timers are available—Recording Timer, Daily Timer and Sleep Timer.

•Before using these timers, make sure the built-in clock is set correctly (see page 17).

•When using the tuner as the source, preset stations in advance (see page 26).

Using the Recording Timer

With the Recording Timer, you can make an unattended recording.

•You can set the Recording Timer whether the unit is turned on or in standby mode.

•To correct a misentry any time during the setting process, press CANCEL.

•To exit from the timer setting mode during the setting process, press CLOCK/TIMER repeatedly until the source indication appears.

•When you want to record onto both sides of a tape, you can set the reverse mode to do so. Recording automatically stops after recording in the 2 direction. Therefore, make sure that the tape direction is 3 when recording with the reverse mode on.

How the Recording Timer actually works

The unit automatically turns on, muting the volume, and starts recording on the tape when the timer-on time comes. Then, when the timer-off time comes, the unit automatically turns off (stands by).

The Recording Timer works only once, but the timer settings remain stored in memory until you reset them or unplug the AC power cord.

1 Press CLOCK/TIMER repeatedly until “REC TIMER” appears in the main display.

The timer ( ) indicator lights up and the REC indicator starts flashing on the display.

•Each time you press the button, the timer mode changes as follows:

REC TIMER DAILY TIMER

Source indication Clock time (canceled)

2 Press SET.

The source name flashes in the main display.

3 Select the source to record.

1)Press ¢ or 4 repeatedly to select the source.

•Each time you press the button, the source changes as follows:

FM AM AUX/MD

•When you select “FM” or “AM,” press SET, then select a preset number by pressing ¢ or 4.

•When you select “AUX/MD”, set the timer function of the external component as well.

2)Press SET.

The hour digit of the timer-on time starts flashing.

4 Press REV. MODE to select the reverse mode.

•When setting the Recording Timer while the unit is in standby mode, you cannot change the reverse mode even if you press REV. MODE.

In this case, the recording will start in the current reverse mode.

•Each time you press the button, the reverse mode changes as follows:

Recording on	Recording on
one side.	both sides once.

*

*will be shown during recording when you select

.

5 Set the timer-on time.

1)Press ¢ or 4 repeatedly to adjust the hour. You can adjust the hour using the number buttons.

2)Press SET.

The minute digit starts flashing.

3)Press ¢ or 4 repeatedly to adjust the minute. You can adjust the minute using the number buttons.

Ex.: When you set timer-on time to 11:30.

4)Press SET.

The hour digit of the timer-off time starts flashing.

61