Huffy 21168202 manual Label should be

Page 12

9.

Stack and bounce bottom (3) and middle (2)

Stack upper pole section (1) to bottom and middle

pole sections together. Bounce pole sections 10. pole assembly and continue bouncing until top pole

 

together until middle section no longer moves

(1) no longer moves toward taped reference mark on

 

toward taped reference mark on bottom pole.

middle pole.

 

 

 

 

5"

 

1-1/2"

 

 

 

 

(12.7 cm)

Tape

(3.81 cm)

 

 

 

 

Tape

 

 

5"

 

 

1-1/2"

 

 

 

 

Tape

(3.81 cm)

 

 

 

(12.7 cm)

 

 

 

 

 

 

 

 

 

Tape

 

 

 

 

 

 

 

 

 

1

 

IMPORTANT!:

 

 

 

 

 

The warning

 

 

2

 

 

label should be

 

 

 

 

 

90 degees from

 

 

 

 

 

uppermost holes

 

 

 

Taped reference marks

 

on top pole (1) -

 

 

 

 

 

see Illustration.

IMPORTANT

 

5

 

 

 

 

Keep on Bottom Pole

 

Wood Scrap

 

 

 

 

 

 

 

 

 

 

 

 

(NOT

5

 

 

 

 

 

SUPPLIED)

 

 

 

 

 

3

 

 

 

 

Wood Scrap

 

 

 

 

 

 

(NOT

 

 

 

 

 

 

SUPPLIED)

 

 

IMPORTANT!:

 

 

 

 

 

 

 

 

 

 

 

 

POLE SECTIONS

 

 

 

 

 

 

SHOULD HAVE A

 

 

 

 

 

 

3-1/2" (9 CM)

 

 

 

 

 

 

MINIMUM OVERLAP.

 

 

 

P/N 21168202

10/04

 

12

 

 

 

Image 12
Contents Inground System Before YOU Start Safety Instructions Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole TOP Middle FIG. a Side View Keep Ground Sleeve CAP on Bottom Pole Label should be Front Side Tighten just until washers 10 stop moving Side Section B Assemble the Elevator Tubes to Backboard 10/04 21168202 10/04 Container to Mix Phillips-Head Screwdriver 4 Wrenches 21168202 10/04 Install Slam Jam Rim to Backboard USE EYE Protection Heavy-Duty Tape Not Included Install clips NET Installation None Use wedge to gently tap cap of ground sleeve 5 until tight 10 ft 05 m