Huffy 21168202 manual USE EYE Protection

Page 22

4.

Insert bolt (27) through left side of short elevator tube (30),

 

then stretch spring or springs (29) onto bolt (27). Insert bolt

 

 

30

 

(27) through right side of short elevator tube (30) and secure

 

with nut (24).

 

24

WARNING!

27

USE EYE PROTECTION

 

WHEN INSTALLING

 

SPRINGS.

 

29

30

Assemble rebar centering spacers

5. (51) near top and bottom of rebar

(50) as shown.

51

2"

50

51

50

6. Place rebar with spacers into bottom pole section (3) as shown.

3

51

3"

Reinforcement Bar

P/N 21168202 10/04

22

Image 22
Contents Inground System Before YOU Start Safety Instructions Parts List See Hardware Identifier Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole TOP Middle FIG. a Side View Keep Ground Sleeve CAP on Bottom Pole Label should be Front Side Tighten just until washers 10 stop moving Side Section B Assemble the Elevator Tubes to Backboard 10/04 21168202 10/04 Container to Mix Phillips-Head Screwdriver 4 Wrenches 21168202 10/04 Install Slam Jam Rim to Backboard USE EYE Protection Heavy-Duty Tape Not Included Install clips NET Installation None Use wedge to gently tap cap of ground sleeve 5 until tight 10 ft 05 m