3.
Snap two halves of ground sleeve (4) together.
Insert and secure bottom pole section
(3)into ground sleeve
(4)by tightening ground sleeve cap (5).
4. Fill hole approximately 1/3 full with mixed concrete.
NOTE: Flared end goes inside ground sleeve.
4 
3
5. | FIG. A |
|
FLANGE
Insert ground sleeve assembly and center in hole (FIG. A).
Note: Leave 1" below flange exposed for drainage hill.
SIDE VIEW
PLAYING SURFACE
1" (2.54 cm)
5
4
IMPORTANT!:
NOTE POSITION OF
FLANGE
IMPORTANT!: CONTINUE ON TO NEXT STEP. DO NOT WAIT FOR CONCRETE TO CURE.
9 | 10/04 | P/N 21168202 |