Spalding M682001 manual Board PAD Installation

BOARD PAD - INSTALLATION

The enclosed Molded Edge Guards interlock together to form bottom and side protection for

one backboard with an overall width of 54".

Check the fit of the edge guards and reposition

1. slightly if necessary. It may be necessary to trim away some material to fit it around the goal or supports. NOTE: CHECK FASTENER LOCATIONS TO MAKE SURE THEY WILL NOT DAMAGE THE BACKBOARD GLASS.

Using a portable drill (with adjustable torque) and a

2. 5/16 socket and extension drill through the backboard frame and secure the pads in place with self-tapping screws provided. Use screws (7) for center pad and screws (4) for outer pads

It may be necessary to use an 11/16 drill bit (6) to pre-drill on some backboards (FIG. A).

A center punch is recommended to mark hole locations prior to drilling to keep drill bit from wandering.

1

3

2

4

If the ends of the screws are exposed after installation, place the screw protectors (5) over the ends to prevent injury.

4 7

FIG. A.

6

4

5

4 or 7

3.

Collect any metal shavings that may have fallen onto the floor or driveway to prevent injury.

23 12/06 ID# M682001