2. | Correctly identify each pole section. Poles have an identification sticker that will be used as a | ||||
| reference point in the next step. |
|
| 5 |
|
|
| MIDDLE |
|
| |
|
|
|
|
|
|
4
|
| IDENTIFICATION STICKER |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| BOTTOM |
TOP |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
6
3. Bounce middle pole section (5) into top section (4) using a wood scrap as shown until the top pole no longer moves toward the pole identification sticker on the middle pole.
IMPORTANT!
Align dimple of top pole section (4) into trough of middle pole section (5) as shown.
| pole em | ID STICKER |
5” | Trough |
|
|
| |
(12.7 cm) |
|
|
|
| pole middle |
|
| 1.5” (3.81 cm) |
|
| DIMPLE |
5
4
CAUTION!
THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 4- 1/2" MINIMUM OVERLAP, LEAVING 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.
HOLE
Wood Scrap (not supplied)
9 | 12/06 | ID# M682001 |