Spalding M60 1111 manual Pole Identification Mark

Page 10

3.Align dimple of middle pole with slot of bottom pole.While maintaining alignment, bounce top and middle pole assembly (1 & 2) onto lower pole section (3) as shown until they no longer move toward pole identification mark.

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2" MINIMUM OVERLAP, LEAVING 1-1/2"

BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

5"

Bottom Pole

IDENTIFICATION

STICKER

NOTE:

POLE SECTIONS SHOULD HAVE A 3-1/2" (9 CM)

MINIMUM

OVERLAP.

POLE

IDENTIFICATION

MARK

1

2

3

IDENTIFICATION

1-1/2"

Bottom Pole

STICKER

 

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH

THE HARDWARE

IMPORTANT!

WOOD SCRAP

(NOT SUPPLIED)

Holes in top (1) and bottom (3) pole sections MUST align to correctly position elevator system toward playing surface.

P/N M601111 08/05

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back Hardware Identifier NUTS, Washers & Metal Spacers Hardware Identifier Plastic Spacers & Caps Wood Board scrap Pole Pole Identification Mark AND/OR Do not Over Tighten 08/05 M601111 M601111 08/05 AND/OR Tighten just until washers 50 stop moving FIG. a M601111 08/05 Tighten ALL Hardware Toward Board Upper Elevator tube Lower Elevator tube Pole 08/05 M601111 M601111 08/05 Install Rim to Backboard Install net Garden Hose or Sand FIG. a Section F Install RIM Cover Section G Height Adjustment and Moving Label
Top Page Image Contents