Spalding M60 1111 manual Before YOU Start

Page 2

BEFORE YOU START!

To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates. Carefully rock them in a circular motion to ream out any excess paint from holes if necessary.

Not all items pictured are included with every model.

WARNING

Read and understand warnings listed below before using this product.

Failure to follow these warnings may result in serious injury and/or property damage.

Owner must ensure that all players know and follow these rules

for safe operation of the system.

DO NOT HANG on the rim or any part of the system including backboard, support braces or net.

During play, especially when performing dunk type activities, keep player's face away from the backboard, rim and net. Serious injury could occur if teeth/face come in contact with backboard, rim or net.

Do not slide, climb, shake or play on base and/or pole.

After assembly is complete, fill system completely with water or sand. Never leave system in an upright position without filling base with weight, as system may tip over causing injuries.

When adjusting height or moving system, keep hands and fingers away from moving parts.

Do not allow children to move or adjust system.

During play, do not wear jewelry (rings, watches, necklaces, etc.). Objects may entangle in net.

Surface beneath the base must be smooth and free of gravel or other sharp objects. Punctures cause leakage and could cause system to tip over.

Keep organic material away from pole base. Grass, litter, etc. could cause corrosion and/or deterioration.

Check pole system for signs of corrosion (rust, pitting, chipping) and repaint with exterior enamel paint. If rust has penetrated through the steel anywhere, replace pole immediately.

Check system before each use for proper ballast, loose hardware, excessive wear and signs of corrosion and repair before use.

Check system before each use for instability.

Do not use system during windy and/or severe weather conditions; system may tip over. Place system in the storage position and/or in an area protected from the wind and free from personal property and/or overhead wires.

Never play on damaged equipment.

When moving system, use caution to keep mechanism from shifting.

Keep pole top covered with cap at all times.

Do not allow water in tank to freeze. During sub-freezing weather add 2 gallons of non-toxic antifreeze, sand or empty tank completely and store. (Do not use salt.)

While moving system, do not allow anyone to stand or sit on base or have added ballasting on base.

Do not leave system unsupervised or play on system when wheels are engaged for moving.

Use Caution when moving system across uneven surfaces. System may tip over.

Use extreme caution if placing system on sloped surface. System may tip over more easily.

See instruction manual for proper installation and maintenance.

In the U.S.: 1-800-772-5346

In the U.S.: 1-800-334-9111

In the U.S.: 1-888-713-5488

In the U.S.: 1-800-558-5234

Canada: 1-800-284-8339

 

ID#: 556790 05/05

P/N M601111 08/05

2

Image 2
Contents Write Model Number From Box Here Before YOU Start Safety Instructions Warranty Card Front Back Hardware Identifier NUTS, Washers & Metal Spacers Hardware Identifier Plastic Spacers & Caps Wood Board scrap Pole Pole Identification Mark AND/OR Do not Over Tighten 08/05 M601111 M601111 08/05 AND/OR Tighten just until washers 50 stop moving FIG. a M601111 08/05 Tighten ALL Hardware Toward Board Upper Elevator tube Lower Elevator tube Pole 08/05 M601111 M601111 08/05 Install Rim to Backboard Install net Garden Hose or Sand FIG. a Section F Install RIM Cover Section G Height Adjustment and Moving Label