JVC MX-J270V Using the Timers, Using the Daily and Recording Timer, Press Select or Select + to

English

Using the Timers

There are three timers available — Daily Timer, Recording		3 Press SELECT – or SELECT + to		– SELECT +
Timer, and Sleep Timer.		set the on-time you want the unit	4	5
Before using the timers, you need to set the clock built in the		to turn on.
unit. (See page 9.)
Using the Daily and Recording Timer
You can set the timer whether the unit is turned on or turned		4 Press SET.
off.
				SET
•	In the source “TUNER,” “CD,” or “TAPE,” the timer acts	“TIMER OFF” appears for 2 seconds, then the		8
		unit enters off-time setting mode.
	as a Daily Timer. Once the Daily Timer has been set, it will
	be activated at the same time every day until the setting is
	turned off.
•	In the source “TUNER REC,” the timer acts as a Recording
	Timer. After the Recording Timer has been performed, the
	details of the setting remain stored but the timer status is set
	to off.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Before you start…

• When using a TUNER or TUNER REC as the source to play, make sure to select the station.

On the remote control ONLY:

1 Press and hold SHIFT during the setting procedure.

2 Press TIMER.

The timer indicator lights up on the display. “TIMER ON” appears for 2 seconds, then the unit enters on-time setting mode.

5

SHIFT

TIMER

2

6

Press SELECT – or SELECT + to	– SELECT +
set the off-time you want the unit 4	5
to turn off (on standby).

Press SET.	SET
The unit enters source selecting mode.	8

– 25 –