JVC MX-J270V CD Direct Recording, Dubbing Tapes, Press Dubbing, To record an AM station Beat Cut

Page 27
Put a recordable cassette into deck B.

On the remote control:

To stop recording temporarily (except when the

playback source is deck A), press REC PAUSE REC PAUSE on the remote control.

The

indicator flashes on the display.

To resume recording, press TAPE 2or TAPE 3 on the remote control.

The indicator stops flashing and remains lit.

To remove the cassette, press EJECT 0for deck B.

To record on both sides — Reverse Mode

Press REVERSE MODE so that the Reverse Mode REVERSE MODE

indicator lights up as —

.

•When using the Reverse Mode for recording, start recording in the forward (3) direction first. Otherwise, recording will stop when recording is done only on one side (reverse) of the tape.

To cancel Reverse Mode, press the button again so that the

Reverse Mode indicator lights up as — .

To record an AM station — Beat Cut

While recording an AM broadcast, beats may be heard (which are never heard when listening to the broadcast without recording it.)

English

To record on both sides — Reverse Mode

Press REVERSE MODE so that the Reverse Mode indicator

lights up as — .

To cancel Reverse Mode, press the button again so that the

Reverse Mode indicator lights up as — .

CD Direct Recording

Everything on the CD goes onto the tape in the order it is on the CD, or according to the order you have made for Program play.

1

2 Place a disc correctly on the circle of the disc tray, with its label side up.

3

Press one of the disc number

CD

 

buttons (CD 1 to CD 3) to select

CD

 

the disc, then 7.

CD

4

Press CD REC START.

CD REC START

 

The

indicator lights up on the display.

 

Deck B starts recording and the CD player starts playing.

If this occurs, press REPEAT repeatedly, while recording, until the beats are reduced.

•Each time you press the button, the display changes to show the following:

CUT 1 CUT 2 CUT 3

REPEAT

When the recording is done, the CD player and deck B stop.

To stop during CD Direct Recording, press 7on the unit (or TAPE 7on the remote control.)

To remove the cassette, press EJECT 0for deck B.

Dubbing Tapes

When dubbing tapes, make sure that the playback direction of deck A and deck B are the same.

1 Press TAPE 23, then 7.

2 Put the source cassette in deck A, and a recordable cassette into deck B.

•Put the cassettes in both decks so that the tapes will run in the forward (3) direction.

3

Press DUBBING.

DUBBING

 

Dubbing starts.

To stop during dubbing, press 7 on the unit (or TAPE 7on the remote control.)

To remove the cassette, press 0EJECT for deck A and EJECT 0for deck B.

To record on both sides — Reverse Mode

Press REVERSE MODE so that the Reverse Mode indicator

lights up as —

.

•When using the Reverse Mode for CD Direct Recording, put a recordable cassette tape into deck B with the font side facing the holder and start recording in the forward (3) direction first. When the tape reaches its end while recording a song in the forward direction (3), the last song will be recorded at the beginning of the reverse side (2).

If you start recording on the reverse side (2), recording will stop when recording is done only on one side (reverse) of the tape.

To cancel Reverse Mode, press the button again so that the

Reverse Mode indicator lights up as — .

– 22 –

Page 26 Page 28
Image 27
Page 26 Page 28
Contents MX-J270V Precaución -- Interruptor Precaución CA-MXJ270V Class Laser Product Precautions IntroductionAbout This Manual Contents Become familiar with the buttons and controls on your unit Location of the Buttons and ControlsFront Panel KHz MHzDisplay window Remote Control Remote ControlIf reception is poor Unpacking Connecting AntennasGetting Started FM antennaTo connect an outdoor AM antenna Connecting SpeakersRelease the finger from the clamp AM antennaConnecting Other Equipment Adjusting the Voltage SelectorTo connect audio-visual equipment Press SET Common OperationsPress Select or + to set TimeSelecting the Sound Modes Setting the AM Tuner Interval SpacingAdjusting the Volume Reinforcing the Bass SoundListening to FM and AM Broadcasts Tuning in a StationPresetting Stations Tuning in a Preset StationBasic CD Operations Playing Back CDsLoading CDs Playing Back the Entire Discs Continuous PlayProgramming the Playing Order of the Tracks Program Play Start the Random play mode On the unit Playing at Random Random PlayPrepare CDs Prepare the discs Repeating Tracks or CDs Repeat PlayPlaying Video CDs and CD-Gs Prohibiting Disc Ejection Tray LockPress the number button Video intro you Want to playback Special Plays for Video CDsPress V.INTRO while press Hold Shift after a picture appears On the TV screenStart playback of the Video CD Playing Video CDs with PBC FunctionPress Highlight while press Prepare Video CDsBasic Flow of Menu Play Operation To play Video CDs without Using Menu ScreenPrepare a Video CD Press Repeat on the unit to select Playing Back Tapes Playing Back a Tape Locating the Beginning of a Song Music Scan To find the beginning of the next song Check the tape direction of deck B RecordingRecording Tapes on Deck B Press Eject 0for the deck BPress Dubbing To record on both sides Reverse ModeCD Direct Recording Dubbing TapesUsing the Microphone Singing AlongSinging Along with Multiplex Karaoke Discs As you sing into the microphone Adjusting Key ControlMicrophone Mixing Masking repeatedly to select Output soundSet the on-time you want the unit Using the TimersUsing the Daily and Recording Timer Press Select or Select + toPress Select or Select + Using Sleep TimerOn the remote control only Press Sleep To adjust the volume level Press SETTimer Priority Maintenance Handling discsCassette decks Symptom TroubleshootingSpecifications JVC 0900KSMMDWHIT
Top Page Image Contents