JVC GVT0203-006A, CA-UXG68, SP-UXG68 Changing the Picture Tone, To select a preset picture tone

Adjusting the Audio Input Level	Remote
	ONLY

If the sound from the component connected to the

AUX jack is too loud or is too quiet when changing from another source to “AUX,” you can change the audio input level through the AUX jack (without changing the volume level).

While the “AUX” is selected as a source...

DVD/AUX	AUX LVL1 AUX LVL2
LEVEL
	AUX LVL3

AUX LVL1 Select this when the sound is too loud with “AUX LVL2” selected. This setting is recommended for listening and recording when connecting an audio device other than a portable audio device to the AUX jack.

AUX LVL2 Select this when the sound is too loud with “AUX LVL3” selected.

AUX LVL3 Select this when listening to a portable audio device or recording the sound from it (initial setting).

Changing the Scanning Mode	Remote	INFO
	ONLY

Select the color system and the video signal mode according to the type of your TV. If you connect a progressive TV to the System through the COMPONENT jacks, you can enjoy a high quality picture from the built-in DVD player by selecting “PAL PRG” or “NTSC PRG.”

SCAN MODE

	9	PAL PAL PRG
		NTSC PRG NTSC
(while holding...)
		ENTER/SET
PAL	Select for a conventional PAL TV.

PAL PRG	Select for a progressive PAL TV.
	Select to enjoy a progressive scanned
	picture with a progressive PAL TV.
NTSC	Select for a conventional NTSC TV.
NTSC PRG	Select for a progressive NTSC TV.
	Select to enjoy a progressive scanned
	picture with a progressive NTSC TV.

Changing the Picture Tone	Remote
	ONLY

•While showing a playback picture on the TV, you can select a preset picture tone, or adjust it and store your own taste.

To select a preset picture tone

1While playing, display VFP setting screen.

	NORMAL
VFP	GAMMA	0
	BRIGHTNESS	0
10
	CONTRAST	0
	SATURATION	0
	TINT	0
	SHARPNESS	0

(while holding...) On the TV

2Select a preset picture tone.

	NORMAL	CINEMA
	USER2	USER1
NORMAL	Normally select this.
CINEMA	Suitable for a movie source.

USER1/USER2 You can adjust parameters and can store the settings.

To remove the screen, press VFP again while holding

SHIFT.

To adjust the picture tone

1Select “USER1” or “USER2.”

• Follow steps 1 and 2 explained above.

2Select a parameter you want to adjust.

TV CH

ENTER/SET

TV CH

GAMMA	Adjust if the neutral color is bright or
	dark (–3 to +3).
BRIGHTNESS	Adjust if the entire picture is bright
	or dark (–8 to +8).
CONTRAST	Adjust if the far and near positions
	are unnatural (–7 to +7).
SATURATION	Adjust if the picture is whitish or
	blackish (–7 to +7).
TINT	Adjust if the human skin color is
	unnatural (–7 to +7).
SHARPNESS	Adjust if the picture is indistinct
	(–8 to +8).

14