Schwinn 202 manual Assembly Stage #2, Attach Rear Stabilizer and Seat Rail to Seat Assembly

Assembly Stage #2

Attach Rear Stabilizer and Seat Rail to Seat Assembly

.

Assembly hardware required:	(4) M8 Allen Bolts 16mm (item #22)
	(4) Flat Washers Ø8 * Ø19 * 2T(item#2)

Step 4: Attach SEAT RAIL (#9) to REAR STABILIZER TUBE (#10) with 4 FLAT WASHERS (#2) and 4 ALLEN BOLTS (#22). Tighten bolts.

Step 5: Place END CAP (#11) on the end of the SEAT RAIL (#9). Make sure the HR CABLE (#47) is strung through the exit slot on the SEAT RAIL before end cap is secured.

Step 6: Insert SEAT PIN ADJUSTMENT KNOB (#3) into SEAT FRAME (#8). Slide the seat assembly from stage 1 onto the SEAT RAIL (#9). Tighten seat assembly to the rail with the SEAT PIN ADJUSTMENT KNOB (#3). Insert HR CABLE (#47) into HR input on the back of the seat assembly.

Step 7: Attach BUFFER (#12), BUFFER PLATE (#13), FLAT WASHER (#14) and SCREWS (#15) to the bottom of the seat rail as illustrated above.