Bushnell 119628C instruction manual Parameter Settings Description, Interval

Parameter	Settings	Description
	(Bold=default)
Interval	10S (second)	Selects the length of time that the
	default, with a	camera will “wait” until it responds
	60M (minute)	to any additional triggers from the
	to1S (second)	PIR after an animal is first detected
	range of settings	and remains within the sensor’s
	available.	range. During this user set “ignore
		triggers” interval, the camera will not
	(60M-1M are set	capture photos/videos. This prevents
	in one minute	the card from filling up with too
	increments,	many redundant images. Settings
	59S-1S are set	begin with 10 second default when
	in one second	parameter is first selected. Note: after
	increments)	setting down past “1S”, settings start
		over at “60M”.
Sensor Level	Low, Normal,	Selects the sensitivity of the PIR
	High, Auto	sensor. The “High” setting will make
		the camera more sensitive to infrared
		(heat) and more easily triggered by
		motion, and the “Low” setting makes
		it less sensitive to heat and motion.
		The High setting can be useful when
		the ambient temperature is warm
		(making it more difficult for the sensor
		to detect animals), and the Low
		setting may help in cold weather if
		the camera is being triggered too
		often by anything warmer than the
		surroundings. “Normal” is for average
		or moderate conditions. The default
		“Auto” setting will allow the camera
		to determine the best setting based
		on its current operating temperature.
		This is an ideal setting if the weather
		is expected to change significantly
		during the period the camera will be
		used.

18