9.Slide the Front Shield Cover (7) upward onto the Upright (4).
While a second person holds the Upright (4) near the Frame (1), connect the Extension Wire (59) to the Main Wire (58).
Insert the Upright (4) into the Frame (1).
Tip: Avoid pinching the wires. Attach the Upright (4) with four M8 x 16mm Screws (65) and four M8 Split Washers (64).
Slide the Front Shield Cover (7) downward to the Frame (1) and press it into place.
10.Identify the Right Pedal (21).
Using an adjustable wrench, firmly tighten the Right Pedal (21) clockwise into the Right Crank Arm (19).
Tighten the Left Pedal (not shown) counter- clockwise into the Left Crank Arm (not shown).
Adjust the strap on the Right Pedal (21) to the desired position, and press the ends of the straps onto the tabs on the Right Pedal. Adjust the strap on the Left Pedal (not shown) in the same way.
9 |
|
|
Avoid pinching |
|
|
the wires |
|
|
7 |
|
|
|
| 4 |
| 1 | 59 |
64 | 58 | |
65 |
| 64 |
|
| 65 |
|
| 64 |
10 |
|
|
19 |
| Strap |
|
| |
|
| 21 |
|
| Tab |
10