JVC CA-MXS6MD manual Connecting Speakers, To connect an outdoor AM antenna

AM antenna Connecting Speakers

1

2

Vinyl-covered

wire

(not supplied)

3

AM loop antenna

(supplied)

1 If cords are covered with insulation, twist the core of

the cord at the end of each cord, then remove the insulation.

2 Connect the AM loop antenna to the AM LOOP terminals as illustrated.

3 Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

You can connect the speakers using the speaker cords.

1
2	3	4
		Red
Red
	Black
	Speaker cord
	Right	Left
	speaker	speaker

1 If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation.

2 Open the speaker terminal.

3 Insert the end of the speaker cord to the terminal.

Match the polarity of the speaker terminals: Red (+) to red (+) and black (–) to black (–).

4 Close the speaker terminal on the rear of the unit.

Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –