JVC CA-MXS6MD manual Creating Your Own Opening and Ending Screens, To erase your own screen

Changing the Title

You can make a correction or change the title.

1 Follow steps 1 to 4 of pages 48 and 49.

2 Press ¿(10) or fl(+10) to select the character you want to correct.

•Make sure that the character you want to change is flashing.

3 Press CANCEL to delete the character you have selected in the above step.

4 Input the correct character by pressing one of the character entry buttons.

5 Repeat steps 2 to 4 of the current procedure to correct more characters.

6 Press ENTER to finish correcting the title.

•If you want to correct another title, select another title entry mode by pressing ¿(10) or fl(+10), press SET, then repeat from step 2 above.

•If you want to finish the correction, go to the next step.

7 Press MD TITLE (or ENTER again) to exit from the title entry mode.

8 Press 0(on the unit) for the MD recorder to eject the MD.

“WRITING” flashes while the editing you have made is being recorded on the MD.

To erase all the characters

Press CANCEL repeatedly in step 3 above to erase all the characters, then go to step 6.

Creating Your Own Opening and Ending Screens

When you turn on or off the unit, you can show your own screens instead of the HELLO and SEE YOU screens.

To create your own opening and ending screens, follow the procedure below.

•You can register up to 26 characters for each screen.

•You have to use the menu for the following operations. For general information on the menu, see pages 59 and 60.

On the unit ONLY:

1 Press to turn off the unit if it is on.

The STANDBY/ON lamp lights red.

2 Call up the Startup Display setting mode.

1)Press MENU.

2)Push the joy control downward ( ) to select “Startup Disp.” (highlighted), then press SET.

3)Push the joy control downward ( ) or upward ( ) to select the screen you want to make, then press SET.

Power on : To make your own opening screen

Power off : To make your own ending screen

Reset : See “To erase your own screen” below.

3 Enter the message using the title entry procedure explained in step 7 on pages 47.

4 Press ENTER/DEMO to finish creating the screen.

5 Repeat steps 2 to 4 to create the other screen if you want.

To erase your own screen

Repeat the above procedure and in step 3, select “Reset.” “Startup disp. Reset!” appears in the main display, and your own screens are erased.

When you turn on and off the unit, the HELLO screen and the SEE YOU screen will appear.

•If you want to erase only one of the screens, erase all registered characters by inserting blanks.

When you unplug the AC power cord or if a power failure occurs

The registered screen messages will be erased.

– 50 –