Life Fitness CT9500 installation manual Heart Rate ARM Mounting Bracket F

Be careful not to pinch any of the cables between the monocolumn assembly and the display console.

Be careful not to overtighten the screws.

4Locate the user-left HEART RATE ARM ASSEM- BLY (#14) (labels stating “USER LEFT” or “USER RIGHT” are located between the bolt holes at the mounting end of the HEART RATE ARM ASSEMBLIES ). Position the mounting end of the user left HEART RATE ARM ASSEMBLY (#14) at the user left HEART RATE ARM MOUNTING BRACKET (F).

Insert the two HEART RATE ARM MOUNTING BOLTS (#2) with WASHERS (#7) through the mounting holes and secure the HEART RATE ARM ASSEMBLY (#14) to the HEART RATE ARM MOUNTING BRACKET.

Connect the 2-PIN CONNECTOR (2-P) leading from within the HEART RATE ARM ASSEMBLY (#14) to the 2- PIN CONNECTOR (2-P) located on the HEART RATE ARM MOUNTING BRACKET.

NOTE: Be sure the notch located at the mounting end of the heart rate arm assembly is facing away from the pedals before attaching the heart rate arn assembly to the heart rate arm mounting bracket.

Do not disturb the cable clamp retaining the heart rate cable to the heart rate arm mount- ing bracket.

Slide a HEART RATE ARM END CAP (#8) over the bolt- ed end of the HEART RATE ARM ASSEMBLY (#14). With two HEART RATE ARM END CAP SCREWS (#5), secure the HEART RATE ARM END CAP (#8) to the

HEART RATE ARM MOUNTING BRACKET (F).

Be careful not to pinch any wire harnesses between parts or to overtighten the screws.

Repeat this step to install the user right HEART RATE ARM ASSEMBLY (#13).

NOTE: It is extremely important the Cross-Trainer be correctly stabilized for proper operation. An unstable unit may cause damage to it.