PART | R0210A | ||||
To locate the parts listed below, see the EXPLODED DRAWING near the end of this manual. | |||||
Key No. Qty. | Description | Key No. Qty. | Description | ||
1 | 4 | 3/8" x 4" Bolt | 49 | 2 | Bottom Incline Assembly Bracket |
2 | 4 | 3/8" x 2 1/4" Patch Bolt | 50 | 2 | Incline Assembly Cover |
3 | 2 | 3/8" x 2" Patch Bolt | 51 | 1 | Incline Assembly |
4 | 2 | 3/8" x 1 1/2" Bolt | 52 | 1 | Incline Latch |
5 | 2 | 5/16" x 5/8" Patch Bolt | 53 | 1 | Incline Catch |
6 | 33 | #8 x 3/4" Screw | 54 | 1 | Electronics Cover |
7 | 4 | #8 x 3/4" Tek Screw | 55 | 1 | Electronics Bracket |
8 | 6 | 3/8" Jam Nut | 56 | 1 | Hex Key |
9 | 12 | 3/8" Star Washer | 57 | 1 | 4mm Hex Key |
10 | 2 | M8 Washer | 58 | 1 | Belly Pan |
11 | 2 | 3/8" Washer | 59 | 1 | Power Cord |
12 | 2 | 1/4" Drive Motor Bolt | 60 | 1 | Power Cord Grommet |
13 | 4 | 3/8" x 2 3/4" Patch Bolt | 61 | 1 | Warning Decal |
14 | 2 | 5/16" x 2 1/4" Bolt | 62 | 1 | Base |
15 | 10 | 1/4" x 2 1/4" Bolt | 63 | 1 | Reset/Off Circuit Breaker |
16 | 2 | M6 x 70mm Bolt | 64 | 1 | Left Upright |
17 | 7 | #8 x 1/2" Machine Screw | 65 | 1 | Left Upright Spacer |
18 | 1 | #8 x 3/4" Machine Screw | 66 | 2 | Wheel |
19 | 4 | #8 x 1" Screw | 67 | 4 | Base Foot |
20 | 24 | #8 x 1/2" Screw | 68 | 2 | Upper Cylinder Cap |
21 | 4 | M4.2 x 13mm Screw | 69 | 2 | Shock Cylinder |
22 | 1 | Retainer Ring | 70 | 2 | Cylinder Spacer |
23 | 10 | 1/4" Nut | 71 | 4 | Bolt Spacer |
24 | 12 | #8 Clip | 72 | 1 | Right Upright |
25 | 1 | #8 Star Washer | 73 | 1 | Right Upright Spacer |
26 | 10 | 1/4" Fender Washer | 74 | 1 | Base Ground Wire |
27 | 14 | Foot Rail Washer | 75 | 1 | Belly Pan Insert |
28 | 2 | M6 Lock Washer | 76 | 1 | Key/Clip |
29 | 1 | Left Foot Rail Accent | 77 | 2 | Wire Tie |
30 | 1 | Right Foot Rail Accent | 78 | 1 | Console |
31 | 1 | Left Foot Rail | 79 | 1 | iFit Live Housing |
32 | 1 | Right Foot Rail | 80 | 1 | Console Ground Wire |
33 | 1 | Reed Switch | 81 | 1 | Left Accessory Tray |
34 | 1 | Reed Switch Clamp | 82 | 1 | Right Accessory Tray |
35 | 1 | Motor Belt | 83 | 1 | Audio Wire |
36 | 1 | Drive Motor | 84 | 1 | Console Base |
37 | 2 | Frame Pivot Bushing | 85 | 4 | Handrail Cap |
38 | 1 | Drive Roller/Pulley | 86 | 1 | Crossbar |
39 | 1 | Magnet | 87 | 1 | Left Handrail |
40 | 1 | Walking Platform | 88 | 1 | Right Handrail |
41 | 1 | Walking Belt | 89 | 1 | Controller |
42 | 1 | Idler Roller | 90 | 2 | Lower Cylinder Cap |
43 | 2 | Belt Guide | 91 | 1 | Upright Wire |
44 | 1 | Roller Ground Wire | 92 | 2 | #8 x 1 1/2" Screw |
45 | 1 | Frame | 93 | 2 | M16 Washer |
46 | 1 | Front Hood | 94 | 1 | Push Nut |
47 | 1 | Front Belly Pan | 95 | 2 | Small Warning Decal |
48 | 2 | Top Incline Assembly Bracket | * | – | Userʼs Manual |
Note: Specifications are subject to change without notice. For information about ordering replacement parts, see the back cover of this manual. *These parts are not illustrated.
24