3.Identify the Right Upright Spacer (73), which is marked with an "R." Orient the Right Upright Spacer so that the "R" is in the position shown. Insert the Upright Wire (91) through the Right Upright Spacer (73). Set the Right Upright Spacer on the Base (62).
Identify the Right Upright (72) which is marked with a “Right” sticker. Have a second person hold the Right Upright near the Base (62), with the bracket in the position shown. See the inset drawing. Tie the wire tie in the Right Upright se- curely around the end of the Upright Wire (91). Then, pull the other end of the wire tie until the Upright Wire is routed completely through the Right Upright.
4.Hold a Bolt Spacer (71) inside the lower end of the Right Upright (72). Insert a 3/8" x 4" Bolt (1) with a 3/8" Star Washer (9) into the Right Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (71), 3/8" x 4" Bolt (1), and 3/8" Star Washer (9).
Hold the Right Upright (72) against the Right Upright Spacer (73). Be careful not to pinch the Upright Wire (91). Partially tighten a 3/8" Jam Nut (8) with a 3/8" Star Washer (9) onto each 3/8" x 4" Bolt (1); do not fully tighten the
Jam Nuts yet.
Remove the wire tie from the Upright Wire (91).
3
91 | 72 | Hole |
| ||
Bracket | "R" | |
Wire | 91 | |
Tie | 62 | 73 |
91 | 72 |
| |
Wire |
| ||
| Tie |
| |
4 | 72 | 1 | |
91 | |||
| |||
Wire Tie | 9 | ||
|
| ||
| 73 | 71 | |
| 8 | 9 | |
|
| ||
8