ProForm PCTL53691 user manual Ties off the Right Handrail, Tie off the Right Handrail, Cut

4. While a second person holds the Right Handrail (85) and

the Console Base (87) near the right Upright (82), cut the

indicated	plastic	ties off the Right Handrail.	Do not cut
the other	plastic	tie off the Right Handrail.	Next, cut

the plastic tie off the Upright Wire Harness (34) in the right Upright (82). Do not drop the Upright Wire

Harness into the right Upright.

Refer to the inset drawing. Connect the Upright Wire Harness (34) to the Console Wire Harness (48). The latch on the Console Wire Harness should snap onto the

Upright Wire Harness. If the Wire Harnesses do not fit together easily, turn them; do not force the Wire

Harnesses together.Next, connect the right pulse wire (with the “R” tag), the left pulse wire, and the ground wire

to the corresponding connectors on the Console Wire

Harness (48); make sure that the wires with tags are connected to each other.

5.Note that there is still a plastic tie in the Right Handrail (85); do not remove this plastic tie.

Position the Right Handrail (85) on the right Upright (82) as shown. The bracket on the base of the right Upright

should be inside of the lower end of the right Handrail, as shown in the inset drawing.

While holding the Console Base (87) near the Right Handrail (85), feed the Console Wire Harness (48) into the Right Handrail. Next, place the Console Base on the Handrails (74, 85). Insert any remaining Console Wire Harness into the Right Handrail.

Thread two Handrail Bolts (78) with Handrail Washers

(36) into the Left Handrail (74) and the left Upright (82) as

shown.	Do not tighten the Handrail Bolts yet.	Next,
thread two Handrail Bolts with Handrail Washers into the
Right Handrail (85) and the right Upright.		Do not tighten

the Handrail Bolts yet. Be careful to avoid damaging the Console Wire Harness (48).

6. Attach the Console Base (87) to the Left and Right Handrails (74, 85) with four Long Screws (114).

Refer to assembly step 5. Tighten the four Handrail

Bolts (78) used in assembly step 5.

Press two Small Upright Plugs (79) into the holes near the upper ends of the Uprights (82).

7. Remove the backing from theWrench Clip (99). Press the Adhesive Clip onto the base of the right Upright (82)

as shown. Press the Allen Wrench (100) into the Adhesive Clip.

8.Make sure that all parts are tightened before you

use the treadmill. To protect the floor or carpet, place

6 a mat under the treadmill.

4	87			48
				34
	Do not
	cut
	Right	Left		Ground
Cut
Plastic		85
Ties
48	34	Cut Plastic Tie
	82
5	87			Do not
				Remove
				this
	48			Plastic
				Tie
78	78
36		36
82	82			85
	74
				85
36	78			Bracket
6	87
114
	79
74		85		114
	82
7
				82
	99		100