ProForm PFTL81910.1 warranty Troubleshooting, Symptom The power turns off during use

Page 25

TROUBLESHOOTING

Most treadmill problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assis- tance is needed, see the front cover of this manual. SYMPTOM: The power does not turn on

a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 15). Use only a single-outlet surge suppressor that meets all of the specifications described on page

15. IMPORTANT: The treadmill is not compati- ble with GFCI-equipped outlets and may not be compatible with AFCI-equipped outlets.

b.After the power cord has been plugged in, make sure that the key is inserted into the console.

c.Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in.

c

 

Tripped

Reset

SYMPTOM: The power turns off during use

a.Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console, and then reinsert it.

d.If the treadmill still will not run, please see the front cover of this manual.

SYMPTOM: The console displays remain lit when you remove the key from the console

a.The console features a display demo mode, de- signed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 22 to turn off the demo mode.

SYMPTOM: The displays of the console do not function properly

a.Remove the key from the console and UNPLUG THE POWER CORD. Remove the three #8 x 1/2" Screws (1) and the two #8 x 3/4" Screws (2). Carefully pivot the Motor Hood (65) off.

a

 

65

1

 

2

 

 

 

 

 

 

2

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model No. PFTL81910.1 Serial No QUESTIONS?Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Instructions Save TheseBefore YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyBe careful not to pinch the wires. Insert See the inset drawing. Tie the wire tieBase Covers into place yet Assembly Then tighten each of them Again. if YOU do not Connect the CONConsole Assembly Make sure to follow all Instructions in this step Have a second person hold the Frame until is completed HOW to Plug in the Power Cord Operation and AdjustmentConsole Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerPage Measure your heart rate if desired. Before using Select an onboard workout HOW to USE AN Onboard WorkoutStart the workout Select an iFit Live workout HOW to USE AN Ifit Live WorkoutStart the workout. See on Follow your progress with the displays. See onMetric Information ModeMake sure that your audio wire is fully plugged HOW to USE the Stereo Sound SystemHOW to Fold the Treadmill HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USESymptom The power turns off during use TroubleshootingStructed to do so by an authorized service rep Symptom The walking belt slows when walked onApply silicone spray or other substances to Walking belt or the walking platform unlessPage Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Key No. Qty Part ListDescription Qty Exploded Drawing a Exploded Drawing B Exploded Drawing C Exploded Drawing D Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents