2.Have a second person hold the Base (52) in the position shown.
Identify the Left Upright (53) (the Right Upright [54] has a large hole near the lower end).
Hold the Left Upright (53) so the two small holes for the latch assembly are on top as shown. Insert two Upright Bolts (2) into the bracket on the Left Upright. Attach the Left Upright to the Base (52) with the Upright Bolts, two Upright Star Washers (9) and two Nuts (16).
Do not tighten the Nuts yet.
Attach the Right Upright (54) to the Base (52) in the same way.
3.Slide the two Wheel Housings (45) onto the Base (52). Attach each Wheel Housing with two Wheel Housing Bolts (13), two Wheel Housing Washers (32), and two Wheel Housing Nuts (43).
4.Position the Base (52) as close to the front of the treadmill as possible, as shown.
See drawing 4a. Locate the wire tie in the lower end of the Right Upright (54). Tie the wire tie se- curely around the end of the Wire Harness (39). Then, locate the other end of the wire tie in the upper end of the Right Upright. Pull that end of the wire tie until the Wire Harness is extending from the upper end of the Right Upright. Secure the Wire Harness to the Right Upright so that it will not fall inside.
See drawing 4b. Press the indicated Grommet (49) into the Right Upright (54).
2 |
|
|
|
2 | 9 |
|
|
|
|
| |
54 |
| 16 |
|
|
|
| |
| 9 |
| 9 |
Large |
| 52 | 2 |
Hole |
|
| 16 |
Small Holes |
|
|
|
|
|
| 9 |
|
| 53 |
|
3 | 32 |
|
|
45 |
|
| |
43 |
| ||
|
| ||
13 | 32 |
|
|
|
|
| |
|
|
| 32 |
|
| 45 | 43 |
|
|
| |
|
| 13 | 32 |
|
|
| |
| 52 |
| |
4 |
| 4a |
|
| 39 | 39 | 54 |
Wire Tie
54
52
4b
54
49
39
52
7