ProForm PFTL49609.0 user manual Top, Problem The walking belt slows when walked on

Idler Roller Bolts

2–3 in.

Remove the three #8 x 3/4" Screws (12) and care-		12
fully pivot the Motor Hood (59) off.	59
Locate the Reed Switch (72) and the Magnet (45)
on the left side of the Pulley (46). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and	1/8 in.
the Reed Switch is about 1/8 in. (3 mm). If nec-
essary, loosen the #8 x 3/4" Truss Head Screw	72	45
(17), move the Reed Switch slightly, and then
retighten the Screw. Reattach the Motor Hood (not		46
shown) with the #8 x 3/4" Screws (not shown).
Reattach the Belly Pan Screws (not shown) if nec-	Top
essary. Run the treadmill for a few minutes to
check for a correct speed reading.	View

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 13.

b. If the walking belt is overtightened, treadmill perfor- b mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG

THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.

c. If the walking belt still slows when walked on, see the front cover of this manual.

23